Diagnosing Better Efficiencies for Solar Cells

Diagnosing Better Efficiencies for Solar Cells

- in Cells, Efficiency, Solar
472
0
CARB_Backside_HDR

A new diagnostic imaging technique developed by a University of Maryland -led team of researchers promises to boost efficiencies of solar cells by making it possible to find and correct previously undetected ways that solar cells fall far short of theoretical efficiencies.

Theory indicates that current solar cell technologies should able to convert solar energy to with at least 30 percent , but the actual efficiencies of current cells is only around 20 percent. Thus produce one third less power than the theoretical maximum of these devices.

“With the new our team has developed, academic and industry researchers will be able to diagnose where lose efficiency and close the gap between theory and the actual efficiencies experienced by consumers who install solar panels on their homes and businesses,” said University of Maryland (UMD) Assistant Professor Marina Leite, in the UMD Institute for Research in Electronics and Applied Physics (IREAP) and the department of materials science & engineering in the A. James Clark School of Engineering.

Solar cell efficiencies depend on the maximum achievable open-circuit voltage generated by the device under illumination. Open-circuit voltage determines how well any photovoltaic device operates, and researchers must be able to measure and image it in order to diagnose which processes are adding to or subtracting from cell efficiency.

The new, ambient temperature imaging technique presented by Leite and her team [Tennyson, et al] is a variation of illuminated Kelvin Probe Force Microscopy, which is a non-contact, non-destructive imaging technique used to determine the composition and electronic state of a surface. Traditionally, this technique uses a laser diode to scan the surface of a solid and measure the potential difference between the tip of the probe and the surface of that material. Tennyson, et al. takes this conventional imaging method further to demonstrate a “direct correlation between Kelvin Probe Force Microscopy measurements (light- minus dark-KPFM) and the open-circuit voltage of photovoltaic devices through the measurement of the quasi-Fermi level splitting”. This indirect measurement allows the UMD-led team to observe precisely [at nanoscale resolution] where the open-circuit voltage is changing.

The researchers say that previous imaging techniques for determining solar cell efficiencies had to be performed under vacuum at very cold temperatures (-333 Fahrenheit or 70 Kelvin). Their new technique fills an important gap in the literature surrounding solar cell efficiencies, providing a “straightforward, universal, and accurate method to measure the open-circuit voltage… with high spatial resolution,” they say.

The findings of Leite and her team are published in, and featured on the cover of, the December 9 issue of Advanced Energy Materials.

Explore further: Dye-sensitized solar cells rival conventional cell efficiency

More information: Solar Cells: Nanoimaging of Open-Circuit Voltage in Photovoltaic Devices. Adv. Energy Mater. DOI: 10.1002/aenm.201570123

Read more at: http://phys.org/news/2015-12-efficiencies-solar-cells.html#jCp

Leave a Reply

Your email address will not be published. Required fields are marked *